Main Page
Hydro-Frac© Process
Equipment
Plastic Pipe Reel
Articles
FAQ's & Myths
Service
Contact
Links

Spafford & Sons, VT.

 

MAX-1-CE:

 - 12K Crane center mounted on a 12' aluminum flat bed with (2) 8' aluminum top side boxes and (2) 2' aluminum bottom side boxes.

 - A Hydro-Frac® Module has been mounted on the deck with water access at both sides, as well as at the back of the truck.

 - This was all mounted on a 2002 Ford F-550 4 x 4 with an 84" CA

- There is an in cab speed control box that is set once and automatically adjusts your engine speed to stay at the desired RPM. (1200-1400) throughout the entire job 

- The aluminum Head Board has curved sides to give the truck a more aero dynamic look and feel.

- All the the crane and jack functions are hydraulic and NO pin is required to keep the mast extensions at in between lengths

 

 

- The center mounted crane has a 12,000# lifting capacity and a 360° continuous rotation.

- 120' per minute line speed (variable). 1' - 12-' per minute and anywhere in between.

 - The control station is portable, it can be carried around your neck (weighs loess than 3 lbs.), or can be attached to any spot on the truck utilizing the built in magnets.

 - All the functions are joystick operated and proportional, once again go as fast or as slow as you need with any of the functions.

 

 

                                                                         

 

Kyle Equipment Co., Inc.
P.O. Box 658, Sterling, Massachusetts 01564
Out of State: (800) 426-6377
In MA: (978) 422-8448

Hydro-Frac® is a registered trademark of Kyle Equipment Co., Inc.
c. 2001-2002 All Rights Reserved. Site designed by tamaradesigns.

This site was last updated on 10/04/2005