The Evolution Pump Hoist is the latest innovation from Kyle Equipment. Comprised of a new KEC pump pulling crane with either a 5,000# or an 8,000# capacity and your choice of a Warner Crane body, or an aluminum flatbed with tool boxes. 

   The 8,000# crane weighs only 1850 lbs, that's less than half of a standard stiff boom pump hoist, and it can be corner mounted on an F-550 size truck leaving the entire bed of the truck open.

   Built off the F-550 (shown here) the total working height of the pump hoist is 37'. 

   There are two body styles to choose from; the Warner crane body (shown here), and an aluminum flat bed with tool boxes. Either of these set-ups can utilize a standard wheel base (60" CA) or an extended wheel base (84" CA) and the utility bodies have a host of options, including pull out drawers, flip top compartments, oxy/ acetylene tank holders. Even a generator/ welder can be placed inside the tool boxes.

   The jack assemblies are completely hydraulic, made to actually lift the truck as opposed to just stabilization, and they feature a hydraulically extendable jack leg (see left pic). This leg extends out 42" from the side of the truck giving it extra support when working off that corner of the truck.

   The crane control station is a small, lightweight hand held pendant. This control station can either be worn around the neck, or magnetically attached to the utility body. The fact that all the crane function are proportional, the more you pull the trigger the faster the function goes (Including the winch   1' - 120' per minute) meaning you have complete control over the entire spectrum of the crane.